This page was last updated: February 2, 2012

Hobbies

Pictures of the Atlas QC42 Turret Lathe

on a WWII Maple Floor Cabinet and it's Accessories

(NFS)

Click on a picture to enlarge

Download 1950 sales add M50-3_5_12.pdf9.4 MB adobe file

Has specifications and attachmentsCan only view not print

With the right Change Gears you can cut 1.1500 to 1000.0000 TPI.,

.25 to 7.0 mm TPI,

can also wind springs and coils

10" Quick Change Lathe QC42 & QC54

TABLE OF CONTENTSGear Setups 4.8Mb pdf file down load

• Operating Instructions __________________________________ 1 -5
  

• Lubrication Chart _________________________________________6
  

• TABLE I -Gear Set-ups for Odd Threads and Feeds __________7 -59
  

• TABLE II -Gear Set-ups for Metric Threads___________________ 60
  

• Gear Set-ups for Coil Winding -TABLES III -XII American
  

• Steel and Music Wire Gauge-TABLE IIL__________________ 61-62
  

• Enamel Covered Magnet Wire -TABLE IV ____________________63
  

• American or Browne and Sharpe
  

• Wire Gauge -TABLE V _______________________________ 64 -65
  

• Washburn and Moen or Steel Wire Gauge-TABLE VI __________ 66
  

• Double Cotton Covered Magnet Wire -TABLE VIL_____________ 67
  

• Single Cotton Covered Magnet Wire -TABLE VIIL_____________ 68
  

• Double Silk Covered Magnet Wire -TABLE IX ._______________ 69
  

• Single Silk Covered Magnet Wire -TABLE X _________________70
  

• Enamel and Single Cotton Covered
  

• Magnet Wire -TABLE XI ________________________________ 71
  

• Enamel and Single Silk Covered
  

• Magnet Wire -TABLE XII ._______________________________ 72