WORKHOLDING
Please fill out the I W T P so I can figure the shipping charge per your request and send you and invoice with a paypal link before you can purchase. You can send other forms of payment.
Thank You for visiting My Website
This page was last updated: May 19, 2010
7.5" XY Rotary Table
Top Has been Blanchard Ground, Paint is ordinal, each dial is graduated by .001", one revolution is .100", there is a casting # on the bottom (700) I believe it was made by MasterCraft, the bottom has a 5/8" x 18tpi taped hole in the center and two 3/8" thru holes for bolting down.
weight - 25 lb's
16"L x 8"H x 16" W
The condition is like new
FMT item # 07062111070-2
$ 245.00
J.P. Hold Down Kit
What you will be getting in the kit 6 aluminum Clamps, 6 Hardened washers, 6 - 1", 6 - 1.5", 6 - 2", 6 - 2.5", 6 - 3" 1/4x20 Bolts on a oak block
Made in the USA
FMT item # JP1
$40.00
Shipping $5.00
Suburban Vac Chuck
VC-612-S2
Provides an excellent means for holding non-magnetic workpieces for light machining or grinding. Designed to bolt directly to a SineSet® sine plate or compound sine plate of the same size & series with little or no indicating. Chuck has back and end rails for positive location of workpieces. Chuck has three 1/4 NPT holes for mounting the vacuum gage, relief valve and hose fitting (not included).
The condition is like new
Weight - 25 lb's
FMT item # 090910-41
$ 475.00
XY Table
Made by Master Craft Sold by Ralmike's
Table is 12" x 5 1/2" and 4 1/2" H
T-slots are 5/8" w
This would be great for any drill press
could be used for drilling gun actions
In very good condition
Weight - 38 lb's
FMT item # 1005192
$ 285.00
